Running Blinky RKH demo on Freescale MCF51QE128 demostration board DEMOQE128. This is a guide to how to setup and use the demo board to evaluate the RKH framework. It assumes a prior knowledge on board features and development environment.

Before to start you must check this jumper settings

J6: RXD-PTB0 close
J7: TXD-PTB1 close
J8: COM_EN ON.
J9: at least PTC0 position close.
J17: EXTAL close, XTAL close.
J18: RESET_EN close, STLED_EN close.

Blinky demo BSP

Blink state is shown through PTC0 Led.
Tracing info through DB9 board connector at 57600 8N1.